Chip cross-section viewer

Pick the chip on your bench. You'll confirm it matches before opening the viewer.

Compare this overview with your die under the microscope. It shows the top metal, which is what you'll see from above. The origin (0, 0) is the lower-left corner of the die in this orientation.

Layers

Opacity

Saved cross-sections

Cross-section line

Pick a direction, then click the chip to place the line. It always runs edge to edge across the die. Drag the line to move it.

Y (µm)

Zero point

Current zero (absolute):

Coordinates are shown relative to the zero. Saved lines always store absolute die coordinates (from the die's lower-left corner).

Cross-section Scroll to zoom, drag to pan, double-click to show that spot on the map. Vertical scale is schematic (split axis).